12-05-2015, 06:22 PM
So many things I want to make now... I don't like the calibration mode because you have to stop the pump at 100ml which is to much room for error, could be hard to do accurately and what if I don't have anything to measure 100ml. I calibrated my pump the other day for the first time and I really like how it worked except for the fact it was missing the run pump button on the calibration screen so I had to go back and forth between screen but it will be there next update. For calibrating I used my test tube from the water test kit, it's 5ml to the line, best thing I could find that I thought would be accurate. I felt using a real measuring cup would be impossible because 1ml isn't going to make a big difference, with 5ml test I can see if its out a little bit, probably down to a 10th with that nice white line on the tube. So I set the dose amount to 5ml and then adjusted the speed of the pump until it pumped exactly 5ml. Was very easy to do. Then I raised the dose amount in different increments until I got to 250ml to test and it was always on, went back down to 5ml and that's what I got.