07-17-2016, 12:29 AM
Hi Dom, yeah you can still use it but not on the ATO ports which means the ATO status light and alerts for it won't work. This is how you would do it.
Plug your DC top up pump in port 5. Then use port 10, 11, 12, 13 or 14 for your optic sensor, you can also use one of those ports for a backup float switch.
Then in the hardware settings go to "expansion ports" and set the ports to a float or sensor for each of them.
Then go to "sensor actions" and press the port you added the optical sensor and set the low level you want it to go off. Then select the ATO pump so it turns on when this happens. Then on the high level sensor set the level and tell it to turn off the ATO pump. Do the same for the float switch and both of them should be controlling the pump. On the PCB make sure the jumpers for the ports you use are set to "other".
Plug your DC top up pump in port 5. Then use port 10, 11, 12, 13 or 14 for your optic sensor, you can also use one of those ports for a backup float switch.
Then in the hardware settings go to "expansion ports" and set the ports to a float or sensor for each of them.
Then go to "sensor actions" and press the port you added the optical sensor and set the low level you want it to go off. Then select the ATO pump so it turns on when this happens. Then on the high level sensor set the level and tell it to turn off the ATO pump. Do the same for the float switch and both of them should be controlling the pump. On the PCB make sure the jumpers for the ports you use are set to "other".
