ATO circuit

[Rob F]

Hi Chris, the float switch needs to be closed, if it's open no power gets to the pump. You'll also need to switch the "High" / "Low" in the sketch for the ATO pump because its backwards.    You don't see the "ports" button because its in the new version. I'm very close to finishing the update, its been a hard one because of the sensor logic. I also made the ATO system better and safer. Now the home page has a small "ATO" icon under the date. When the icon is gray the system is idle, when the icon is green the ATO is running and if it turns red the ATO malfunctioned. If you turn the alerts on you get an email when the ATO starts and stops and you always get an email if the ATO malfunctions. There's now a setting where you can set the maximum amount of time the ATO pump is allowed to run, if the pump runs longer than the set time the ATO is shut down, the icon turns red, an email is sent and the system will never restart until you press the ATO icon and press ok. This is good because you'll know when the optical sensor needs cleaning, that's whats being checked.