02-03-2024, 09:06 PM
Hello,
I setup a 12v pump on DC1 of the equipment extension for an ATO using timers instead of sensors. I set the timers as "on then off" after 10 seconds. I had 4 timers setup. One each at 1 pm 3 pm 5 pm and 7pm. It seemed to work until I came home after a dog walk at 7:30pm and noticed my sump was over my fill line.
The pump was coming on every 50 seconds for 10 seconds.
Any idea what happened?
As I was searching for this problem I came across advice to use separate timers to turn on and off.
Maybe I'll try that.
Thanks
Greg - Edmonton
I setup a 12v pump on DC1 of the equipment extension for an ATO using timers instead of sensors. I set the timers as "on then off" after 10 seconds. I had 4 timers setup. One each at 1 pm 3 pm 5 pm and 7pm. It seemed to work until I came home after a dog walk at 7:30pm and noticed my sump was over my fill line.
The pump was coming on every 50 seconds for 10 seconds.
Any idea what happened?
As I was searching for this problem I came across advice to use separate timers to turn on and off.
Maybe I'll try that.
Thanks
Greg - Edmonton