Posts: 436
Threads: 23
Likes Received:
8 in 8 posts
Likes Received:
8 in 8 posts
Reputation:
8
Joined: Sep 2015
Country:
Ok so this is the first time I have installed this software So my understanding is the software is it will only show what is connected to it only. I have a fresh install and only have the 9 blue icons on the bottom row of the screen. i have tried to hook up a few different ph probes to it but nothing happens or shows up after reboot of the pi and I am not sure what the connector page is or not I dont seem to have that
So what am I doing wrong?
Posts: 3,245
Threads: 90
Likes Received:
163 in 120 posts
Likes Received:
163 in 120 posts
Reputation:
184
Joined: Sep 2015
Country:
If you installed 6.3 you likely won't get a pH probe or temp sensors, need 6.0 or wait a little bit for 6.4.
To enable other things you need to go to "settings", then "configure ports". Now click on a port and enable it and set the function to what it will be used for. Then on the home page things will start to appear.
Posts: 436
Threads: 23
Likes Received:
8 in 8 posts
Likes Received:
8 in 8 posts
Reputation:
8
Joined: Sep 2015
Country:
ok so i should of waited LOL
Posts: 3,245
Threads: 90
Likes Received:
163 in 120 posts
Likes Received:
163 in 120 posts
Reputation:
184
Joined: Sep 2015
Country:
Yeah that's probably best, just a little longer. :)
Posts: 436
Threads: 23
Likes Received:
8 in 8 posts
Likes Received:
8 in 8 posts
Reputation:
8
Joined: Sep 2015
Country:
I still need to find the green part that the wires hook to for the rest of the sensors
Posts: 3,245
Threads: 90
Likes Received:
163 in 120 posts
Likes Received:
163 in 120 posts
Reputation:
184
Joined: Sep 2015
Country:
I'm guessing it's in one of those part bins. :)
