Wiring Analog 0-10v lights

[hemiroyd]

Hi.  I have  an older(2012) Iventronics 40W 700ma LED driver i'm trying to add to the robo controller analog ports.  The LED driver has 3 wires for dimming control.  1-10v(input), 10v(output), ground.  I changed my dip switches to analog 10v.  But there's only one wire connection for each channel port on the robo board.  I can use the common ground on the controller board to connect to my dimming ground but not sure if I connect the 1-10v input, or 10v output dimmer wire to the channel port on the controller board?  I guess i could try different combinations of wiring but I don't want to short anything out.

[Rob F]

Hi hemiroyd, you'll want to connect the 1-10v input to the controller LED channel and the ground to a common ground point on controller.

[hemiroyd]

Hi hemiroyd, you'll want to connect the 1-10v input to the controller LED channel and the ground to a common ground point on controller.

That did the trick.  Thanks Rob!!

[Rob F]

No problem, glad things are working.