11-03-2020, 12:05 PM
Hi. I have an older(2012) Iventronics 40W 700ma LED driver i'm trying to add to the robo controller analog ports. The LED driver has 3 wires for dimming control. 1-10v(input), 10v(output), ground. I changed my dip switches to analog 10v. But there's only one wire connection for each channel port on the robo board. I can use the common ground on the controller board to connect to my dimming ground but not sure if I connect the 1-10v input, or 10v output dimmer wire to the channel port on the controller board? I guess i could try different combinations of wiring but I don't want to short anything out.