Posts: 164
Threads: 6
Likes Received:
9 in 9 posts
Likes Received:
9 in 9 posts
Reputation:
9
Joined: Nov 2015
Country:
Hi Rob,
My humidity sensor allways shows 1° and 1%. It was ok at beginning. I have change the sensor without result. Any idea what about that?
Thanks
Dom.
Posts: 3,250
Threads: 90
Likes Received:
163 in 120 posts
Likes Received:
163 in 120 posts
Reputation:
184
Joined: Sep 2015
Country:
Hi Dom, that's different, did you check the voltage on the USB jack? Should be 5v on 2 pins. The sensor uses pin 33, check to make sure you have 5v there as well. If you have access to the sensor pins check voltages there as well.
Posts: 25
Threads: 3
Likes Received:
0 in 0 posts
Likes Received:
0 in 0 posts
Reputation:
1
Joined: Dec 2015
Country:
Hey Dom,
I ran into that same issue a few times. For me it was caused by applying the incorrect voltage to the sensor, the temp would still read accurately but the humidity would always read 1%.
I would try and run just the humidity sketch to see if the values change, if they remain at 1% chances are you need to replace the humidity sensor.
Best of luck!
Posts: 164
Threads: 6
Likes Received:
9 in 9 posts
Likes Received:
9 in 9 posts
Reputation:
9
Joined: Nov 2015
Country:
I changed sensor without success. As Rob suggests, i will check voltage, but not before next weekend...