well got to take the LCD box back to work need to re-solder the buzzer back on and glue the screen back down guess I need to stop dropping it on the ground. :(
Rob I am ordering a new box that is a little wider than the one I have now for the expansion board my plan is to drill holes in front of each usb plug and run the usb wire threw it and solder the wires to the plug inside then just have a tail hanging out from the box. can you or some one tell me what the 4 pins are on the back of the usb I think it is
left to right pin#1notused ,pin#2 Data ,pin#3vcc ,pin#4 gnd
Just not sure if that is right
Rob I am ordering a new box that is a little wider than the one I have now for the expansion board my plan is to drill holes in front of each usb plug and run the usb wire threw it and solder the wires to the plug inside then just have a tail hanging out from the box. can you or some one tell me what the 4 pins are on the back of the usb I think it is
left to right pin#1notused ,pin#2 Data ,pin#3vcc ,pin#4 gnd
Just not sure if that is right
