09-13-2019, 12:47 AM
At any point did you make adjustments to the speed sliders for the ports? If you haven't can you go to settings, hardware, DC accessories and move the max sliders down to around 50% and see if the output voltage drops.
What controller PCB do you have? Based on timeline I'm thinking it's one of the first Gen3's which has resistor arrays. These were a lot smaller than I expected and were difficult to solder so I quickly changed to individual resistors. With that said I did screw up soldering on a couple of those arrays and wondering if that's the issue although this theory doesn't completely fit because you were switching it for a little while but maybe. If you let me know the controller board I will mark some points to check voltages on the board.
What controller PCB do you have? Based on timeline I'm thinking it's one of the first Gen3's which has resistor arrays. These were a lot smaller than I expected and were difficult to solder so I quickly changed to individual resistors. With that said I did screw up soldering on a couple of those arrays and wondering if that's the issue although this theory doesn't completely fit because you were switching it for a little while but maybe. If you let me know the controller board I will mark some points to check voltages on the board.
