09-09-2019, 10:30 PM
That solenoid should work, as it's 12v you'll want the port set to 100%. These port pins are all GND's so when testing with volt meter using any +12v pin and then GND on the accessory port.
If you customize the home page so the 4 DC port show you can touch them and the manual screen will open where you can turn on/off like the outlets. Once that works you can setup the schedules.
Once you get it working you might want to setup a custom rule using a float switch. If possible place it so if too much water is drained the float triggers and can close the valve.
If you customize the home page so the 4 DC port show you can touch them and the manual screen will open where you can turn on/off like the outlets. Once that works you can setup the schedules.
Once you get it working you might want to setup a custom rule using a float switch. If possible place it so if too much water is drained the float triggers and can close the valve.