Updated the display and controller and the controller got caught in a reboot loop. In the serial monitor, it showed connecting to router for a few seconds then would reboot. I had to modify the if statement in the startInternet method to have it skip that section.
I'm not sure if the web is enabled on my controller or not, however, the Ethernet cord is currently plugged into the controller but not connected to any router (i use powerline adapters and it's currently not connected)
UPDATE: Good news! Clicking around the "Update" screen allowed me to start the update. I had changed the UTouch.h file to use the one from the Calibration files section and it threw off the hitboxes. Restored the original and all is well. Please ignore below
It seems that I'm unable to initiate the update. Display is showing:
Update Available! but when I click on the OK button nothing seems to be happening. I waiting 10 minutes or so after clicking it the first time but its still displaying the same update screen on the display. It does seem to briefly flash and redraw the display upon clicking OK for the first time however. Serial monitor for the controller shows:
Starting Robo-Tank v5.20
Initializing sd card...
SUCCESS - sd card initialized.
SUCCESS - Found index.html file.
This should read 50: 50
Starting Controller -------------------
Internet is not enabled
Startup Complete ----------------------2715
Serial monitor for the display shows:
Starting Robo-Tank v5.20
Initializing sd card...
SUCCESS - sd card initialized.
SUCCESS - Found robotank.raw file.
Eeprom Test - This Should Read 50: 50
Starting Controller -------------------
I'm not sure if the web is enabled on my controller or not, however, the Ethernet cord is currently plugged into the controller but not connected to any router (i use powerline adapters and it's currently not connected)
UPDATE: Good news! Clicking around the "Update" screen allowed me to start the update. I had changed the UTouch.h file to use the one from the Calibration files section and it threw off the hitboxes. Restored the original and all is well. Please ignore below
It seems that I'm unable to initiate the update. Display is showing:
Update Available! but when I click on the OK button nothing seems to be happening. I waiting 10 minutes or so after clicking it the first time but its still displaying the same update screen on the display. It does seem to briefly flash and redraw the display upon clicking OK for the first time however. Serial monitor for the controller shows:
Starting Robo-Tank v5.20
Initializing sd card...
SUCCESS - sd card initialized.
SUCCESS - Found index.html file.
This should read 50: 50
Starting Controller -------------------
Internet is not enabled
Startup Complete ----------------------2715
Serial monitor for the display shows:
Starting Robo-Tank v5.20
Initializing sd card...
SUCCESS - sd card initialized.
SUCCESS - Found robotank.raw file.
Eeprom Test - This Should Read 50: 50
Starting Controller -------------------