04-11-2019, 10:00 PM
Sorry I don't understand "den Srom hab ich schon unterbrochen,"?
I don't know how this happened but it seems like the controller is in a never ending loop based of a bad setting. If you don't see "startup complete" the display will stay on 1 red square. Unfortunately you will have to upload the "pre-update" sketch from v5.11 download on the controller, after uploading check serial monitor so you see when it finishes running, takes about 7 minutes. After that upload 5.11 again and you should get start completed and display will go. Then you need to go to settings, system and press restore defaults.
I don't know how this happened but it seems like the controller is in a never ending loop based of a bad setting. If you don't see "startup complete" the display will stay on 1 red square. Unfortunately you will have to upload the "pre-update" sketch from v5.11 download on the controller, after uploading check serial monitor so you see when it finishes running, takes about 7 minutes. After that upload 5.11 again and you should get start completed and display will go. Then you need to go to settings, system and press restore defaults.