Robo-Tank v5.10 is Ready

[Rob F]

Will it get fixed in the next update?
I like to switch off everything that is not in use to make it as lean and clean as possible

Yeah I'll get that fixed soon. That's why I added it so you could make clean and lean but in comparison to v4.2 it's doing ok. I never did do a check with 4.2 but I'm guessing it would have been around 400 per second instead of 1900. If v5 if you disable enough sensors it can jump to over 9999.

I do not remember. Ports of v5 are not the same than v4. Is there a list for that? My t° sensor is on plug 5 of board ( sensor 1) and on v5 it’s port 9.... I am a little bit confuse....

It's actually not too confusing once you know. ;) If you have your ports marked on Gen2 change the names to match Gen3. To get the updated port numbers use the face plate for Gen3 as a reference. 

https://www.robo-tank.ca/forum/Thread-Co...-Faceplate

On Gen2 temps are water = 1, air = 2, light = 3, temp 1 = 4, temp 2 = 5, temp 3 = 6, temp 4 = 7.  On the top row of face plate is the sensor number, which is these numbers, so temp 1 = Port 9 on Gen3. 

DC accessory 1 on Gen2 = Port 17 on Gen3 according to the face plate. Just follow everything like this.

As you see Gen3 doesn't have temp 6 or 7 and a few others are missing, soon those will be made available again to you.

Bei mir geht seit heute Nachmittag garnichts mehr sync sybol rot  nach neustart nur startbilschirm , sd karten wurden beide gefunden , hab jetzt keine heizung und filter mehr , nix geht . Ich habe nichts verändert

Sorry to hear this Addi, did the controller just restart itself? Did you try disconnecting all power to see if it starts up? When you look at the Arduino IDE serial monitor for controller does the last line say "Startup Complete.........."? Does the eeprom line during startup show 50 or 255?