Robo-Tank v5.10 is Ready

[Rob F]

Ill try to fiddle with the outlets tomorrow.
Strange thing is that when the controller is running the outlet turns green if activated by a schedule
But it stays grey if its activated during start-up (always on or schedule doesn’t matter)

As for the sensors, yes I disabled all the Ports and sensors which are not in use, I was trying to find a comparison picture for the Ports But got distracted.

Lights run correctly, I named them 1-7 still need to come up with better names :p

I think last night I discovered a problem if a type of port is all disabled. For example, there are 2 flow meters, if both disabled there might be problems, I think enabling one of each type will work but for now enable them all. It's not really a functioning problem but data being sent from controller isn't being received by display correctly when all of one type is disabled. Right after you enable it'll restart and outlets will likely show correctly.

I have trouble coming up with names as well lol, mine are mode 1, mode 2 etc...

for controller, i have that (without sdcard):

ERROR - sd card initialization failed!
ERStarting Robo-Tank v5.11
Initializing sd card...
ERROR - sd card initialization failed!
ERROR - Can't find index.html file!
This should read 50: 50
Starting Controller -------------------

---

Controller seems to be frozen.
There is only one red brick on screen even if I restart

That looks good but controller is in a loop and can't finish starting, one more line should show in a few seconds "startup finished". The display will never start until that line appears for the controller. Looks like that pre-update sketch didn't take, try uploading it again, should only need to do on controller. While it's running open the serial monitor so you see it says finished. Then upload v5.11 again on controller and it should fire up. Might need to do a full power cycle after uploading.