04-07-2019, 08:53 AM
(This post was last modified: 04-07-2019, 09:34 AM by fietsenrex.)
for some reason I can't get the calibration sketch working.
I know it worked when I loaded 4.2 and did the calibration...
it's attached to the controller for power and is attached by USB on my pc, but the screen stays black...
EDIT: without the ethernet attached it also won't start..
EDIT2: for some reason the touch is inverted in some parts of the screen in some menu's and is normal in that part in another menu
I know it worked when I loaded 4.2 and did the calibration...
it's attached to the controller for power and is attached by USB on my pc, but the screen stays black...
EDIT: without the ethernet attached it also won't start..
EDIT2: for some reason the touch is inverted in some parts of the screen in some menu's and is normal in that part in another menu