04-06-2019, 12:08 PM
Ah I thought you made the move, then unfortunately your plan won't work for this update. You will have to mount the Arduino on the board with the pre-updated loaded on the Arduino. Once the controller or display is powered up the Arduino will start the pre-update so at that point wait 7 minutes. You don't need to mount the Arduino to program the pre-update but you have to mount it and let it run as you would normally power up the controller, the USB port on computer doesn't have enough power for the board so you will need to plug into your main power supply when it runs.
EDIT: you can use the same Arduino to pre-update both display and controller. After you do one move ARduino to other, power up and wait. Then proceed to v5.1.
EDIT: you can use the same Arduino to pre-update both display and controller. After you do one move ARduino to other, power up and wait. Then proceed to v5.1.