02-17-2019, 02:31 PM
Rob,
I just finished wiring and hooking up the same eheim feeder to my reef tank and I'm having an issue on the Gen 3.
- Works with batteries and by using the feed button.
- Once hooked to the controller, power is on for the unit after hooking up according to your attached picture: Brown to ground, White to Port 14 "Feeder", and Orange to +3.3v
I went to feed and pushed the "Auto-feed" button. Pumps and powerheads turned off as normal but drum never rotated. Noticed on the feeder page, was "Feeder Disabled" so I enabled it, stopped the current feed, and initiated it again. Still didnt rotate the drum.
Thought maybe I had switched the White and Orange and changed them on the controller side. When I plugged it in, the drum kept turning. Any ideas?
I just finished wiring and hooking up the same eheim feeder to my reef tank and I'm having an issue on the Gen 3.
- Works with batteries and by using the feed button.
- Once hooked to the controller, power is on for the unit after hooking up according to your attached picture: Brown to ground, White to Port 14 "Feeder", and Orange to +3.3v
I went to feed and pushed the "Auto-feed" button. Pumps and powerheads turned off as normal but drum never rotated. Noticed on the feeder page, was "Feeder Disabled" so I enabled it, stopped the current feed, and initiated it again. Still didnt rotate the drum.
Thought maybe I had switched the White and Orange and changed them on the controller side. When I plugged it in, the drum kept turning. Any ideas?