I've updated to V5.10 last night. I have the same ATO issue. I just saw your request to un-commented the line above, so I will try that tonight. In reference to the ATO timeout (ATO going red on the display). It is strange, I have saw it go red a couple times in the last couple months. But it doesn't do it all the time.
Also i will check the voltage on Pin A5.. per you comment
main ATO is on A5 but what caught my eye is you say you get 5v directly at Arduino, it should only be 3.3v, there's a voltage divider that drops the 5v from float to 3.3v for Due."
Is there a way i can map the Main float to a different Input pin?
I looked and searched in the ato.h file for that code line and no results were found in either V5.10 or V5.04. Should I add it to the code in V5.10, and where? Also after i upload the sketch, do i just open the serial monitor line to see the print value as i open and close the Main Float?
Also i will check the voltage on Pin A5.. per you comment
main ATO is on A5 but what caught my eye is you say you get 5v directly at Arduino, it should only be 3.3v, there's a voltage divider that drops the 5v from float to 3.3v for Due."
Is there a way i can map the Main float to a different Input pin?
I looked and searched in the ato.h file for that code line and no results were found in either V5.10 or V5.04. Should I add it to the code in V5.10, and where? Also after i upload the sketch, do i just open the serial monitor line to see the print value as i open and close the Main Float?
