03-12-2019, 02:11 PM
(03-10-2019, 10:46 PM)Rob F Wrote:Finally was the arduino that got crazy so i bought a new and it's ok now.(03-10-2019, 02:19 PM)niksunen Wrote:(03-10-2019, 01:26 PM)Rob F Wrote: It will be gen 2 with that version so yeah v5 will work. :)
Ok sounds good. Is there any hw mods that i need to make ? I read that version 4.0 needed re-locate rtc chip to controller from display side. I try to look, but there wasn't 4.0 sketch's in download area, so i cannot check if there had some instructions etc.
You only have to move the RTC, the pins on the RTC are marked and you only need to plug into the spare headers on controller board, use the shortest cable possible.
(03-10-2019, 03:36 PM)johnrc Wrote: The last schedule is not fading.........it is the same from the beggining till the end of schedule
Can you send me your settings, I'm not sure what's going on.
https://www.robo-tank.ca/forum/attachment.php?aid=386
I'm trying to upload the attached sketch and a window appear on the pc screen and says:
Failed tto open sketch:"c:\Users\johnrsktop\backup_v5.ino
Am i doing something wrong?