03-11-2019, 07:15 PM
That's happening because the computer can't communicate with the Due, sometimes Due's have issues erasing themselves before programming, if they can't do this you get no device found.
To solve you can press the erase button the due, different than reset, it's located near the center of the board. Before upload you press and hold for about a second then it will work.
2nd option use the other USB port on the Due which is the native USB port. If you set the board type to native port it'll program and about 10 times faster than the programming port however you can't use the serial monitor with the native port.
To solve you can press the erase button the due, different than reset, it's located near the center of the board. Before upload you press and hold for about a second then it will work.
2nd option use the other USB port on the Due which is the native USB port. If you set the board type to native port it'll program and about 10 times faster than the programming port however you can't use the serial monitor with the native port.