03-03-2019, 05:54 AM
(03-01-2019, 07:38 PM)aquaalgae Wrote: If I remember correctly, it has happened every day.
Ok so I sent you some updated sketches for display and controller. If you aren't running the exact settings you sent me can you first upload the backup sketches you sent me, I prefer that just so we know it's fixed, I'm going upload yours again to run as well. Let it run for a few days or until your comfortable its fixed then you can remove all those other test schedules you setup.
Just so you and others understand I will explain. There's a section of code that creates a list and translates all the schedules into unix time format and sorts them so the next is first in line. It then marks the next time stamp and the ID for that schedule. Then when the schedule actually runs it will look for that ID it marked in the list of schedules (should be first) and once found triggers the schedule actions. At the end of this is checks if the next schedule in line has the same time stamp, as in multiple schedules set for the same time, if the next schedule in list is a match it runs as well, this continues until the schedule time stamp is different and then it looks at all the schedules again and gets the next time stamp and ID.
Now I believe the problem was at some point the schedules were being auto sorted as that can happen via 2 other functions that can run depending on other settings or actions. That means the schedules weren't in the expected order on the list so the next time stamp didn't match and why the first schedule, outlet 5, only and always turned off, it was found using the marked ID.
I can't say 100% that will fix the issue because I didn't actually track down when the auto sorted was happening but it definitely could happen so either way this was a bug and 95% confident the cause of your issue.
That's why I haven't posted an updated yet for download as I want to run for a couple days myself to make sure its fixed.
I also happened to notice there was a problem when you viewed the outlet schedules. You have them sorted by ID descending and you probably saw on page 1 ID 8 and 7 are the last two schedules but when you went to page 2 you see ID 8 and 7 at the top. Because of that the touch didn't line up and was off by 2 rows. That's been fixed so you can now sort away. Just to clarify the sorting on display has no effect on the controller list.
Aquaalgae I also want to thank-you for your patience, I should have asked for your settings a week ago.
If you upload your backups first there's no way to know when it finishes so let it run for 7 minutes before uploading v5.05.
