02-27-2019, 08:00 PM
There's only one piece of code that is used everywhere to turn outlets on/off, so if it works with resume it'll work with anything else. Also I setup my outlets to match yours and everything on power bar 2 turned off at 6pm. I just put together a sketch to copy all your settings into a sketch so I can upload to mine and monitor. Upload this to your display then open the Arduino IDE serial monitor, and at the bottom of monitor uncheck the "autoscroll" option. This takes about a minute to run, you'll know it's finished because it's not printing to the serial monitor anymore.
When finished copy everything into a text file or Arduino sketch and save as display, then do the same to the controller.
When you finish you can upload v5.04 again, none of your settings will change so after uploading 5.04 you're back to where you started.
Just to clarify, the outlets remain on and the display also says outlets are on?
When finished copy everything into a text file or Arduino sketch and save as display, then do the same to the controller.
When you finish you can upload v5.04 again, none of your settings will change so after uploading 5.04 you're back to where you started.
Just to clarify, the outlets remain on and the display also says outlets are on?
