Robo-Tank v5.0 is Ready

[jlysaght3]

Hey Rob,

I upgraded to 5.01 and everything worked great for about a week. I lost power to the controller and my display would not progress past 1 bar. I upgraded to 5.02 to have the most up to date firmware/software and I am still getting the same result. I have left the controller powered on/connected and the display will not progress past 1 bar. None of my accessories are functioning, and my power bar has not responded to any signals from the controller despite being plugged in (I suspect due to the fact the controller is not booting properly).

I reloaded 5.02 twice, and the only error I received was that the controller could not initialize the SD card because the "index.html file could not be found", however the only file in the 'files for controller microsd card' folder with a similar name is "index.htm" (specifically '.htm', not '.html'

What steps should I take to resolve this? Most of my equipment has redundancy, except for my ATO, which on a 150 gallon tank with 40 breeder sump @78F results in just under 1 GPD evaporation, which is my main concern