02-11-2019, 07:57 PM
(This post was last modified: 02-11-2019, 08:18 PM by jasbeckett.)
Updated to 5.01 today and it seems to have fixed the heater and schedule issues that I was seeing. The parameters on the left hand side of the screen still don’t update until you leave the home page and return to it. When I start the controller they stay on N/A until I go to another page. When I return they read the current temps etc. still trying to confirm if they are updating once they initially display. The atlas circuits still are not functioning. The controller locks up on startup and will not load until the circuit is disconnected and controller is restarted. I also noticed in the ATO there is no evidence of a backup float available.
I just confirmed that the parameters on the left hand side of the screen are not updating at all except for the initial reading. Additionally screen will not fade to off at all. Stays on at full brightness all of the time.
I just confirmed that the parameters on the left hand side of the screen are not updating at all except for the initial reading. Additionally screen will not fade to off at all. Stays on at full brightness all of the time.