02-10-2019, 06:15 PM
(02-10-2019, 05:23 PM)Yeah I tried a power cycle and independently restarting the display and controller as well as restarting the controller. I am also noticing the schedules appear to be acting a little wonky and don’t seem to be resuming properly. I am not sure if it is a bug or if I still just getting used to there behavior. For example Have fudge light scheduled to come on at 7:30 pm and go off at 6:30 am. When I checked on the tank this afternoon the fudge light was still on and the schedule didn’t reset until I went into the schedules and looked at the off schedule. The outlet it is attached to was not in manual mode at the time.Rob F Wrote: Hey guys, I will send you a sketch via email to test, this time it will only read the ph circuit but you should still be able to plug them all in.
Thanks for feedback jasbeckett, a little surprised about those things and will look into them. The heaters are setup as you expect, when temp hit 77 it should turn on and not be touched again till temp hits 78 when it shuts off and stays off till 77.
The temps not updating on the home page blows my mind, every second data is coming into the display and when sitting on the home page it shows that data where it should. I'm guessing you tried a power cycle?
