02-10-2019, 05:23 PM
Hey guys, I will send you a sketch via email to test, this time it will only read the ph circuit but you should still be able to plug them all in.
Thanks for feedback jasbeckett, a little surprised about those things and will look into them. The heaters are setup as you expect, when temp hit 77 it should turn on and not be touched again till temp hits 78 when it shuts off and stays off till 77.
The temps not updating on the home page blows my mind, every second data is coming into the display and when sitting on the home page it shows that data where it should. I'm guessing you tried a power cycle?
Thanks for feedback jasbeckett, a little surprised about those things and will look into them. The heaters are setup as you expect, when temp hit 77 it should turn on and not be touched again till temp hits 78 when it shuts off and stays off till 77.
The temps not updating on the home page blows my mind, every second data is coming into the display and when sitting on the home page it shows that data where it should. I'm guessing you tried a power cycle?