02-06-2019, 03:50 PM
Ok so someone has reported success with the update so I'm wondering if you both only updated the display thinking maybe you could check that out before doing the controller? If so you have to update controller as well, the display won't turn on without the controller.
There's also a couple other images I forgot to move over so for today keep the images from v4.2 on the display SD card as I need to go through everything to make sure there's no other images I missed. There's a handful I reused such as the keyboard and was planning to rename to fit new naming system but forgot.
Also another important thing I forgot to mention for Gen 2 hardware users. Today you will only have access to the ports Gen 3 has, this means the last 2 temp ports, last 2 flow meter ports and dosing pump 5-8 won't work. I had to much to track so left it for today but will probably do something so you get access back to them.
Also all the references to port numbers are for Gen 3, as an example it will say one analog port is "Port 3" but on Gen 2 it's something else. So the best thing to do is change the labels on your controller to match the port numbers on Gen 3. If you look at the face plate on the home page banner image you can see what sensors/equipment go with each port number.
There's also a couple other images I forgot to move over so for today keep the images from v4.2 on the display SD card as I need to go through everything to make sure there's no other images I missed. There's a handful I reused such as the keyboard and was planning to rename to fit new naming system but forgot.
Also another important thing I forgot to mention for Gen 2 hardware users. Today you will only have access to the ports Gen 3 has, this means the last 2 temp ports, last 2 flow meter ports and dosing pump 5-8 won't work. I had to much to track so left it for today but will probably do something so you get access back to them.
Also all the references to port numbers are for Gen 3, as an example it will say one analog port is "Port 3" but on Gen 2 it's something else. So the best thing to do is change the labels on your controller to match the port numbers on Gen 3. If you look at the face plate on the home page banner image you can see what sensors/equipment go with each port number.
