02-06-2019, 02:36 PM
Oh no, sorry guys, I did forget to change and include the splash screen.
It sounds like the display isn't plugged into the controller, have you tried resetting the controller with display attached?
It turns on the same as v4.2, first the controller, then the display. The display will remain at 1 red dot until the controller tells the display to go which isn't happening.
If you open the Arduino IDE serial monitor on the controller and set baud to 115200, what do you get? This is what you should see.
Initializing sd card...
SUCCESS - sd card initialized.
SUCCESS - Found index.html file.
Starting Controller -------------------This should read 50: 50
Internet setting is not enabled
Startup Complete -------------------1802
It sounds like the display isn't plugged into the controller, have you tried resetting the controller with display attached?
It turns on the same as v4.2, first the controller, then the display. The display will remain at 1 red dot until the controller tells the display to go which isn't happening.
If you open the Arduino IDE serial monitor on the controller and set baud to 115200, what do you get? This is what you should see.
Initializing sd card...
SUCCESS - sd card initialized.
SUCCESS - Found index.html file.
Starting Controller -------------------This should read 50: 50
Internet setting is not enabled
Startup Complete -------------------1802
