04-08-2023, 10:35 AM
Hey Rob,
Thank you for pointing out the ATO, had to go back and add a additional Rule that if the Tank sensor is touching the water for more than 1 sec, TURN OFF the ATO pump.
That is an interesting way to turn ON the devices based on the float switches. I sometimes turn OFF the return and the skimmer while I am dosing so that the food does not go through the filtration section of the AIO tank. This will cause the water level to rise in the rear section of the AIO and will make the system think that the power just turned ON and start the skimmer and return. I think it will not work in my case given the small tank and the way I am doing things.
One more suggestion that you could include in the software is the ability to record parameter test values. Should be daily easy for the basic parameters, Parameter name - standard limits. Values will be the test value and automatic date and time recording. You could show the values as a table initially and then work towards the charts.
I have to say this - I have the first version of Robo Tank and am still very happy with the product
. It is a work horse. Prior to this I put a lot of money into Vertex Cerebra and the whole thing was a waste of money. Keep up the good work Rob. I will get the latest version one I setup my second tank. Glad that you are building software that is still compatible with the older hardware. 
Thank you for pointing out the ATO, had to go back and add a additional Rule that if the Tank sensor is touching the water for more than 1 sec, TURN OFF the ATO pump.
That is an interesting way to turn ON the devices based on the float switches. I sometimes turn OFF the return and the skimmer while I am dosing so that the food does not go through the filtration section of the AIO tank. This will cause the water level to rise in the rear section of the AIO and will make the system think that the power just turned ON and start the skimmer and return. I think it will not work in my case given the small tank and the way I am doing things.
One more suggestion that you could include in the software is the ability to record parameter test values. Should be daily easy for the basic parameters, Parameter name - standard limits. Values will be the test value and automatic date and time recording. You could show the values as a table initially and then work towards the charts.
I have to say this - I have the first version of Robo Tank and am still very happy with the product
. It is a work horse. Prior to this I put a lot of money into Vertex Cerebra and the whole thing was a waste of money. Keep up the good work Rob. I will get the latest version one I setup my second tank. Glad that you are building software that is still compatible with the older hardware.
