Rob,
This might be interesting...
I checked all channels in different modes.
What I noticed is this: it looks like at the very early beginning the slider values or not known and the ouput is 0V, no pulses...
Let me put it this way, I found a couple of channels that had no output signal what so ever, eventhough the slider was somewhere between the top and bottom.
So an output should be there.
When you touch the slider only once, the output works flawless.
This is the same in all light modes.
Could it be that there's no slider value in eeprom at the early startup/first startup?
Or that the value is 0 eventhough the slider shows something different?
Kind regards,
Arne.
This might be interesting...
I checked all channels in different modes.
What I noticed is this: it looks like at the very early beginning the slider values or not known and the ouput is 0V, no pulses...
Let me put it this way, I found a couple of channels that had no output signal what so ever, eventhough the slider was somewhere between the top and bottom.
So an output should be there.
When you touch the slider only once, the output works flawless.
This is the same in all light modes.
Could it be that there's no slider value in eeprom at the early startup/first startup?
Or that the value is 0 eventhough the slider shows something different?
Kind regards,
Arne.