12-25-2021, 09:52 PM
I'm getting a similar issue (no Ph probe or temperature sensors) after a clean new install using the v3 file but did have one problem after the initial install.
initially apache didn't like the last line of its configuration file (which is php related) and wouldn't start so no http access
I got around that by running the following command: sudo apt-get -y install phpmyadmin
I was able to then log in via the browser and ran the wizard but it didn't pick up the pH probe or temp sensors
I rebooted a number of times and also disconnected and reconnected the probes with no changes.
I'm going to restart from scratch again in the morning and see if the above is repeatable.
Config: Pi Zero 2W, 8GB sd card, Raspian Lite, running headless so everything is done via intel laptop with windows 10, putty SSH and a chrome browser
initially apache didn't like the last line of its configuration file (which is php related) and wouldn't start so no http access
I got around that by running the following command: sudo apt-get -y install phpmyadmin
I was able to then log in via the browser and ran the wizard but it didn't pick up the pH probe or temp sensors
I rebooted a number of times and also disconnected and reconnected the probes with no changes.
I'm going to restart from scratch again in the morning and see if the above is repeatable.
Config: Pi Zero 2W, 8GB sd card, Raspian Lite, running headless so everything is done via intel laptop with windows 10, putty SSH and a chrome browser