12-25-2021, 11:46 AM
Well I got an email overnight from someone who said they couldn't access the "advanced" tab on configure ports page after the update. I just checked and sure enough I can't load the page either. Using the browser console it was obvious what the problem was, I removed a variable last minute thinking it wasn't being used. Then I thought I better plug in a new DS18B20 sensor and yeah nothing happened, it still works as expected for an existing sensor. I suspect it's the same with pH as you experienced. I actually checked these things after the update but then last minute I thought I would remove a bunch of variables I didn't think were being used...
Whenever you get back to this just install v6.1 and ignore the update for 6.2, I'll look at this over the next few days.
Whenever you get back to this just install v6.1 and ignore the update for 6.2, I'll look at this over the next few days.