06-27-2021, 05:01 PM
Interesting, sounds like something is interfering, any chance something is turning on when that happens? Have you tried disconnecting everything from controller and running only the probe for a few hours? Is the probe cable running near any AC cords?
Did the probe calibrate ok? If the values you got during the calibration were close to expected I would think the probe is ok but I have seen strange results with a bad probe. I think it might be worth a little more troubleshooting before getting another probe but this is a decent one.
https://www.amazon.ca/Milwaukee-Instrume...da4dea34d6
I see what looks like a probe fully submersed in your pic of tank, if that's correct most probes can't be fully submersed, only the bottom half or so.
Did the probe calibrate ok? If the values you got during the calibration were close to expected I would think the probe is ok but I have seen strange results with a bad probe. I think it might be worth a little more troubleshooting before getting another probe but this is a decent one.
https://www.amazon.ca/Milwaukee-Instrume...da4dea34d6
I see what looks like a probe fully submersed in your pic of tank, if that's correct most probes can't be fully submersed, only the bottom half or so.