05-07-2021, 04:34 PM
Ah summer is nice, we are slowly getting there. The cooling is ready, in the end the cage fan is better but louder. I can print a lid or case for you, just need lid but color wouldn't match. If you choose the cage fan the lid only needs 4 small holes to mount it, screws did come with so it was very easy to mount which is a plus. Those guides I tried on the lid didn't make much change, the air is blowing towards the Pi and gets under the Pi and goes across the full top which is nice. My guides tried moving under the Pi but across top is just as good. You'll need to solder the power wires to the input plug or you could solder to a DC port and can adjust the speed / control with reef-pi.
