08-06-2019, 07:06 PM
That new issue you just discovered is related. It appears the incoming sensor data isn't always going where it should. It's possible the sync didn't fix it as the issue could be on the display. Try the following.
Go to settings, hardware, equipment connected and make sure all boxes are checked. Before leaving this page cycle each setting as in uncheck and recheck. After it restarts then go to settings, hardware, temp settings and cycle each of the options for the 5 ports. Then restart again and hopefully it's fixed.
If this doesn't work, sorry to ask so many times, but what Rev version of controller board do you have?
Go to settings, hardware, equipment connected and make sure all boxes are checked. Before leaving this page cycle each setting as in uncheck and recheck. After it restarts then go to settings, hardware, temp settings and cycle each of the options for the 5 ports. Then restart again and hopefully it's fixed.
If this doesn't work, sorry to ask so many times, but what Rev version of controller board do you have?