06-16-2019, 05:33 AM
Hi Rob
Good work with ver 5, it looks great and controller is very smooth and upgrading software was all ok,
having few issues setting up of ATO, port number dont make any sense when compared to original instructions manual,
ATO main float switch which is connected to port 3, plug3, is reading ok, however unable to see ATO back up switch, it was connected to port 2 plus 2 and was working ok, however now when i select port 2 then no change on switch input,
also ATO pump was connected to port 4 plug 4 but no longer working or selectable,
Can u please help,
also no network connection, does it need to enable in controller anywhere?
Good work with ver 5, it looks great and controller is very smooth and upgrading software was all ok,
having few issues setting up of ATO, port number dont make any sense when compared to original instructions manual,
ATO main float switch which is connected to port 3, plug3, is reading ok, however unable to see ATO back up switch, it was connected to port 2 plus 2 and was working ok, however now when i select port 2 then no change on switch input,
also ATO pump was connected to port 4 plug 4 but no longer working or selectable,
Can u please help,
also no network connection, does it need to enable in controller anywhere?
