06-16-2019, 02:13 PM
When you first updated to v5 did you run the "pre-update" sketch in the package?
I'm thinking when you do the restore defaults its only happening on the display so you will have to try and load the pre-update sketch on both display and controller. After the upload completes leave the display alone for about 7 minutes, then upload to controller and do the same. Then upload the 5.13.
I'm thinking when you do the restore defaults its only happening on the display so you will have to try and load the pre-update sketch on both display and controller. After the upload completes leave the display alone for about 7 minutes, then upload to controller and do the same. Then upload the 5.13.