06-12-2019, 03:52 AM
Hi Rob,
Today I updated the controller from 4.2 to 5.13 as directed. I followed everything written. After the launch, the controller was updated normally and everything was OK. But all the inscriptions are back. Even when I pressed "Connect Equipment", the "Flow meters" menu opens. Everything is reversed. Is it possible that the CPLD 7 inches calibration file that I put in the library is the problem.
All the best
Today I updated the controller from 4.2 to 5.13 as directed. I followed everything written. After the launch, the controller was updated normally and everything was OK. But all the inscriptions are back. Even when I pressed "Connect Equipment", the "Flow meters" menu opens. Everything is reversed. Is it possible that the CPLD 7 inches calibration file that I put in the library is the problem.
All the best