05-24-2019, 10:28 PM
I have a feeling it will get worse as it's pretty bad right now, I can't even imagine it drifting 30 minutes. Adding another won't be too difficult though. Here's an image with the 2 traces highlighted where its safe to cut. There is one trace close to it so you'll have to be steady.
These are the SCL/SDA lines to it so once cut the controller won't find it obviously. With the RTC module connect it to +5v, GND, SCL and SDA headers on controller board and you should be good.
These are the SCL/SDA lines to it so once cut the controller won't find it obviously. With the RTC module connect it to +5v, GND, SCL and SDA headers on controller board and you should be good.