04-20-2019, 01:36 AM
Hi, I have an update available, this one requires you to copy some images to the display SD card and upload sketch to display and controller, nothing else needs to be done and no current settings are affected.
This update covers the following.
This update covers the following.
- The first incoming sensor data was converted to an integer instead of a float, if all analog sensors were disabled the first temperature sensor didn't show the tenths or anything after the decimal but 0
- Moved equipment pin setup to top of startup so dosing pumps and DC accessories don't run during startup
- 1st Gen I2C power bar - If connected to controller outlets are now turned off immediately after a restart until controller finishes starting, about 2-3 seconds, then they resume their proper mode
- Fixed LED sliders on light mode pages from locking up
- Fixed customize labels screen menu - if too many equipment types were disabled the list was messed up and could only access some categories
- Added non-contact sensor to sensor type selection for ATO
- Added sensor images under the sensor type for ATO for better clarity
- Added non-contact sensor image for home page custom sensor boxes
- Disabled ATO emails if ATO is in TEST mode