04-18-2019, 11:17 AM
Just updated to the 5.12 and I noticed a couple issues. Some related to new update, some not:
Specific to 5.12:
-ATO primary 'non-contact sensor' switch is reading "1" and ATO is continuing to run
Not specific to 5.12:
-After updating the controller and as its rebooting, the ATO will start running immediately until the controller fully boots
-Freezing of the display when adjusting light percentages, rebooting the display by holding the top left corner fixes the issue
Specific to 5.12:
-ATO primary 'non-contact sensor' switch is reading "1" and ATO is continuing to run
Not specific to 5.12:
-After updating the controller and as its rebooting, the ATO will start running immediately until the controller fully boots
-Freezing of the display when adjusting light percentages, rebooting the display by holding the top left corner fixes the issue