07-27-2019, 01:04 PM
Yeah that is possible. The 120v boards just need a short jumper added (which I would do) because of that transformer then it can be used for 230v, you can solder the wires from outlets directly to the board.
One other thing, I haven't been able to tune the energy consumption for 230v as I don't have it. You can either do this if you have/get one of those Kill-A-Watt meters. This would involve uploading some sketches to the controller which will change the calibration values in the power bar. If you don't want to do this once I have the correct calibration values you can then upload the changes.
One other thing, I haven't been able to tune the energy consumption for 230v as I don't have it. You can either do this if you have/get one of those Kill-A-Watt meters. This would involve uploading some sketches to the controller which will change the calibration values in the power bar. If you don't want to do this once I have the correct calibration values you can then upload the changes.