03-05-2019, 05:41 PM
Hello Rob,
I upgraded to v5.02 and have discovered a potential bug in the software, but I cannot identify its root cause. Here is what I am facing:
Robo-Tank, 1 power bar connected (8 outlets)
ATO system (working fine)
4 Dosing pumps
4 channels LED light control (working perfectly on a schedule)
2 Auxiliary float sensors (ATO low water + skimmer/UV light off based on sump water level to identify when the return pump is shut off)
2 water temp sensors (display and sump - working perfectly)
air humidity/temp sensor (working perfectly)
Current configuration:
I have the return pump, heater/chiller, UV light, skimmer all set on an ALWAYS ON schedule (also tried on at 00:00 daily) and these outlets do not switch on in automatic mode, as set through the schedules page
I have a few custom rules set up:
* Heater/chiller off below X degrees, off above Y degrees
* Skimmer and UV set to turn off when a float switch is triggered (sump level rises, indicating return pump has been turned off; and on when sump level drops to normal)
I also have some alert-only custom rules set
Here is the challenge I am facing:
Outlet schedules are not functioning properly
No matter what settings I use, only the heater (outlet 2) is operating as expected under normal operation.
All other outlets (return pump, air stone, UV light, skimmer) can be manually operated on or off, but when I hit "resume schedule" these outlets all turn off
What steps can I take to correct or properly diagnose this?
I upgraded to v5.02 and have discovered a potential bug in the software, but I cannot identify its root cause. Here is what I am facing:
Robo-Tank, 1 power bar connected (8 outlets)
ATO system (working fine)
4 Dosing pumps
4 channels LED light control (working perfectly on a schedule)
2 Auxiliary float sensors (ATO low water + skimmer/UV light off based on sump water level to identify when the return pump is shut off)
2 water temp sensors (display and sump - working perfectly)
air humidity/temp sensor (working perfectly)
Current configuration:
I have the return pump, heater/chiller, UV light, skimmer all set on an ALWAYS ON schedule (also tried on at 00:00 daily) and these outlets do not switch on in automatic mode, as set through the schedules page
I have a few custom rules set up:
* Heater/chiller off below X degrees, off above Y degrees
* Skimmer and UV set to turn off when a float switch is triggered (sump level rises, indicating return pump has been turned off; and on when sump level drops to normal)
I also have some alert-only custom rules set
Here is the challenge I am facing:
Outlet schedules are not functioning properly
No matter what settings I use, only the heater (outlet 2) is operating as expected under normal operation.
All other outlets (return pump, air stone, UV light, skimmer) can be manually operated on or off, but when I hit "resume schedule" these outlets all turn off
What steps can I take to correct or properly diagnose this?
