Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Control original LED lights
#11
I found this Chip when I correct understood
I stepdown 5 Volt pwm with stepdown module to the voltage each channel needed
eg 3,26 Volt after I put some ICL7660 to turn around voltage. See attachment
Make a bridge from cap +/-
Connect ground 
Connect v+ on stepdown eg 3,26 Volt and into the led channel
Vout to turn around voltage.
I test it when I can get robo Controller if mainboard is available!
I hope you soon have new main boards!
because it tingles so slowly in the fingers
To setup Robo Tank to my new system


Attached Files Image(s)
       
206 gallon tank, 42 gallon technic sump, system triton core 7, 8 dosing Pumps, AM Aquarius, AM Reef LED, AM Ocean LED at TC420, AM Temp controller, Skimmer Bubble Magus Curve M7, 3 Tunze flow pumps at Tunze Multi Controller 7096, AM refill system pro
Reply to top


Messages In This Thread
Control original LED lights - by Gordon Lehmann - 02-28-2019, 01:21 AM
RE: Control original LED lights - by Rob F - 02-28-2019, 02:45 PM
RE: Control original LED lights - by fietsenrex - 03-01-2019, 07:58 AM
RE: Control original LED lights - by Rob F - 03-01-2019, 06:57 PM
RE: Control original LED lights - by Rob F - 03-02-2019, 07:52 PM
RE: Control original LED lights - by Rob F - 03-03-2019, 03:54 AM
RE: Control original LED lights - by Gordon Lehmann - 03-05-2019, 02:23 AM
RE: Control original LED lights - by Rob F - 03-05-2019, 10:50 PM
RE: Control original LED lights - by Rob F - 03-06-2019, 02:55 PM
RE: Control original LED lights - by Rob F - 03-19-2019, 11:26 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Powerhead Control Ideas Rob F 17 15,375 04-29-2018, 06:58 PM
Last Post: Rob F
  16 Channel LED Signal Converter PCB Rob F 28 29,267 06-13-2016, 11:39 PM
Last Post: Rob F

Forum Jump:

Current time: 03-29-2024, 12:58 AM