Connecting Analog Sensors to Robo-Tank
|
Connecting Analog Sensors to Robo-Tank
|
Posts: 3,250
Threads: 90 Likes Received: 163 in 120 posts Likes Received: 163 in 120 posts Reputation: 184 Joined: Sep 2015 Country: 
02-17-2019, 06:33 PM
Your board does have that 390ohm resistor on the main ATO sensor port so you can connect the optical sensor directly. You also have those jumpers for the 5 analog ports on the right side. If you set those jumpers to "Enabled" the 390ohm resistor will be used.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Connecting Analog Sensors to Robo-Tank - by Rob F - 02-15-2019, 06:18 PM
RE: Connecting Optical Water Sensor - by midwestE - 02-16-2019, 08:49 AM
RE: Connecting Optical Water Sensor - by Rob F - 02-16-2019, 04:46 PM
RE: Connecting Analog Sensors to Robo-Tank - by Dom59 - 02-17-2019, 02:36 AM
RE: Connecting Analog Sensors to Robo-Tank - by Rob F - 02-17-2019, 08:03 AM
RE: Connecting Analog Sensors to Robo-Tank - by Dom59 - 02-17-2019, 08:10 AM
RE: Connecting Analog Sensors to Robo-Tank - by Rob F - 02-17-2019, 06:33 PM
|
| Possibly Related Threads… | |||||
| Thread | Author | Replies | Views | Last Post | |
| Connecting | Rob Wheatley | 12 | 10,939 |
09-10-2018, 05:54 PM Last Post: Rob F |
|
| analog signal | jimsreef | 6 | 8,896 |
04-13-2016, 09:06 PM Last Post: Rob F |
|
| Video - Connecting Expansion Hub To Controller For The First Time | Rob F | 0 | 6,312 |
03-01-2016, 04:30 PM Last Post: Rob F |
|
| Current time: 05-03-2024, 06:15 PM |
