02-06-2019, 03:43 PM
Hi Simone, glad to hear you got it installed, did you have any trouble with the install?
I looked into the missing keyboard, this was an image I forgot to copy over. You also didn't see the splash screen when display turns on for the same reason. For today copy all the images from v4.2 back to your display SD card in case there's a couple others I forgot, I'll have to go through it to make sure I got them all.
For the port not working this is something I forgot to mention. I didn't setup the controller to cover all the ports on Gen 2 hardware, now Gen2 becomes Gen3 basically. This means you won't have access to all 7 temp sensor ports, now you can only use 5 of them. The last two you can't, "temp3 and temp4". You also will lose access to the last 2 flow meter ports and the last 4 dosing pumps.
It's possible you will gain access again to those ports but I just had too much to track without trying to make the software cover two board types. I hope this isn't a big problem for you.
The Sensor parameter page currently isn't working, will be soon. All you will get is a bunch of empty boxes.
I looked into the missing keyboard, this was an image I forgot to copy over. You also didn't see the splash screen when display turns on for the same reason. For today copy all the images from v4.2 back to your display SD card in case there's a couple others I forgot, I'll have to go through it to make sure I got them all.
For the port not working this is something I forgot to mention. I didn't setup the controller to cover all the ports on Gen 2 hardware, now Gen2 becomes Gen3 basically. This means you won't have access to all 7 temp sensor ports, now you can only use 5 of them. The last two you can't, "temp3 and temp4". You also will lose access to the last 2 flow meter ports and the last 4 dosing pumps.
It's possible you will gain access again to those ports but I just had too much to track without trying to make the software cover two board types. I hope this isn't a big problem for you.
The Sensor parameter page currently isn't working, will be soon. All you will get is a bunch of empty boxes.
