02-06-2019, 03:31 PM
Hi Rob,
first of all I'm very happy with the new look of the v 5.00!!!
I'm trying to connect my hardware to my REV-E board following the "Robo-Tank Gen2 Connecting the Equipment.pdf" file.
I think that there's something wrong (or that I'm doing wrong)
To test it I connect a DHT22 to Plug 7 on the pin labeled as "Light" which should be Port 9. I set the type sensor on Port 9 to DHT22 but on the main screen and even in the Sensors tab I couldn't see anything.
If I set it to Port 11 (even if it connect to port 9) it now works on the main page but not on the Sensor reading tab.
Another strange thing is that the keyboard to customize the labels didn't show on the screen but this is regarding the software...
Thank you vvery much!
Simone
first of all I'm very happy with the new look of the v 5.00!!!
I'm trying to connect my hardware to my REV-E board following the "Robo-Tank Gen2 Connecting the Equipment.pdf" file.
I think that there's something wrong (or that I'm doing wrong)
To test it I connect a DHT22 to Plug 7 on the pin labeled as "Light" which should be Port 9. I set the type sensor on Port 9 to DHT22 but on the main screen and even in the Sensors tab I couldn't see anything.
If I set it to Port 11 (even if it connect to port 9) it now works on the main page but not on the Sensor reading tab.
Another strange thing is that the keyboard to customize the labels didn't show on the screen but this is regarding the software...
Thank you vvery much!
Simone
