02-24-2019, 05:55 PM
Hi jlysaght3, glad its working but why that Atlas shield is causing problems is a mystery. I just can't understand how this update could have any effect. I have the I2C setup with the same speed and the library for it is part of the Arduino IDE so not something I ever update, the code I use is exactly the same as v4.2 in reference to calls on the I2C bus.
Eventually I imagine I'll have multi-circuit boards but for now I have jumpers so they can easily daisy chain and go in the same case. If they are side by side it would the same physical size as if they were on the same board. I actually have the boards similar to the pH but I need to get an EC and ORP circuit from Atlas and a probe for each so I can set these others up, unfortunately I'm not sure when that will happen.
Eventually I imagine I'll have multi-circuit boards but for now I have jumpers so they can easily daisy chain and go in the same case. If they are side by side it would the same physical size as if they were on the same board. I actually have the boards similar to the pH but I need to get an EC and ORP circuit from Atlas and a probe for each so I can set these others up, unfortunately I'm not sure when that will happen.