Robo-Tank v5.0 is Ready

[Rob F]

Also the light function on schedules doesn't work for me  .Only the lights on settings work.

I've been running my lights the last week using schedules so it does work for some at least on some level. Are you sure you setup "daily light modes" and not temporary light modes? The temp modes you can set schedules but they don't work yet, only schedules for daily schedules work.

Also if you haven't always try a restart if something is working properly to see if that sorts it out, if it does let me know what it sorted out.

Right I have re uploaded v5 onto both the display and the controller (had to remove the Arduino from the controller as it will not connect via the external USB unless the controller is powered up), re loaded the v4 files onto both SD card and then copied the v5 to them replacing the old with the new, re connected everything (sensors & display but not the power bars) and its still the same, power on, v4 splash with v5.00 top left and one red block at the bottom, does nothing else no matter how long I leave it, no message to update.
If I open the serial monitor I get
Initializing sd card...
ERROR - sd card initialization failed!
ERROR - Can't find index.html file!
Starting Controller -------------------This should read 50: 255

What format should the controller SD card be? fat, fat32 etc?

Ok I see the problem, there's two. The SD card isn't being initialized but that doesn't matter to much right now as only web data is stored. However I'm guessing that would go away if you unplugged card, plugged back in and reset. The format should be fat32. 

The main problem is the last line of text you posted, at the end of last line it has 255 but that should be 50.

This means the eeprom is being read and that can happen after a programming. After you program power down everything and power back up and it should be ok. 

Quite a few have loaded it up now so it is working, I think it just needs to be powered down after programming